Seam re-welding
Open seams cleaned and re-welded with hot air, then probed to confirm the weld.
Call (929) 219-1763PVC roofs are common on Brooklyn restaurants, stores and newer buildings because they resist grease and chemicals. When a seam opens or the membrane is punctured, we repair it with heat-welded PVC that fuses with your roof.
We repair PVC only with compatible PVC materials. Asphalt-based patches and sealants damage PVC and void its warranty.
Open seams cleaned and re-welded with hot air, then probed to confirm the weld.
Call (929) 219-1763Holes and cuts covered with a welded PVC patch that fuses with the roof.
Call (929) 219-1763Loose or split flashing at walls, curbs and edges re-welded or replaced with PVC-coated metal.
Call (929) 219-1763Pipe boots, vents and drains resealed with pre-formed PVC accessories.
Call (929) 219-1763Damage around kitchen exhaust fans repaired, plus rooftop grease containment and walkway protection where needed.
Call (929) 219-1763Older PVC that has shrunk and pulled at walls and edges is relieved and stripped in with new welded PVC.
Call (929) 219-1763PVC is repaired by heat-welding new PVC onto the old membrane. The price depends on seam and flashing length, and on whether the PVC has become brittle with age, because brittle sheet needs larger patches to hold a weld. Most PVC repairs in Brooklyn cost $300 to $1,500.
You get a written price after a free inspection, before any work starts.
Call for your exact price| Repair | Typical Brooklyn price |
|---|---|
| Puncture or small hole, heat-welded patch | $300 – $650+ |
| Penetration or pipe boot repair | $350 – $800+ |
| Seam re-welding | $400 – $1,100+ |
| Flashing repair at walls, curbs or vents | $450 – $1,300+ |
| Brittle membrane section replacement | $800 – $2,200+ |
| Leaks in several areas | $1,500 – $4,000+ |
| Emergency call outside business hours | add $200 – $350+ |
PVC holds up well, but these signs mean water is close to getting in.
Call for a free inspectionA PVC patch lasts only when it fully welds to clean membrane. We prepare every repair the same way.
Most PVC problems are repairable. If the membrane has become too brittle to weld across most of the roof, or the insulation underneath is wet over large areas, a new roof costs less in the long run. You’ll see photos and get both prices.
Emergency on your PVC roof? We answer 24/7.
Call (929) 219-1763They look almost the same. The original paperwork, a label on the roof or a small sample tells them apart. It matters because each must be welded with its own material.
Most PVC repairs are done in a few hours to one day. Welding needs a dry roof, so in rain we make a temporary seal and finish once it dries.
Yes, as long as the roof is dry and clear of snow and ice. We adjust the welder for the cold and test every weld.
If your roof is still under a manufacturer warranty, check its terms first. Some require a certified contractor. Send us the warranty and we’ll tell you how to keep it valid.
Free inspection, photos of the problem, and a written repair price before any work starts.